Working principle of automatic canning and sealing machine

Automatic seamers are generally used in automatic production lines and mass production lines.

Fundamental:

1. When the clay pot is poured into the seaming machine from the upper high-speed canning.

2. The pots are brought to the seaming machine by the rotation of the six forks. The clay pot is covered by a fully automatic lid dropper.

3. The six forks rotate again for the next process, and the first coiler is gradually pre-coiled.

4. The six-fork rotates again for the next process. The second rolled edge snaps the edge tightly.

5. Finished product output.

Common problems and maintenance methods in the whole application process of automatic seaming machine:

When using the automatic seaming machine, the customer needs to spare a low-position large tank with a valve and an output connector at the bottom. The impact of the large tank on the bottom of the tank is higher than that of the automatic seaming machine. Use a plastic hose to connect with the machine. Top valve butt. Connect the electromechanical engineering machine to the 220V power main switch (the electrical switch is reserved by the customer) and connect the human body casing to the grounding wire.

After the automatic seaming machine is installed, first check whether there is looseness at each position, whether the left and right sides of the top valve can be sensitive, and after checking that everything is normal, open it for a trial run, and the overall rotation direction is listed in order before leaving the factory. The hour hand rotates. Adjust the relative height of the water bottle seat according to the lifting system. Adjust the length of the canned tube to reach the position of the canned liquid level.

A part of the transmission system of the automatic can sealing machine is driven by the motor according to the belt pulley and the V-belt to drive the reducer gear and the transmission wheel of the Coke bottle automatic sealing machine to rotate and then promote the overall rotation. Maintenance and maintenance In order to make the machinery and equipment have the best firmness and service life, regular maintenance is essential to keep the machinery and equipment in the best condition.